Horizontal Skateboard Wall Mount – Acrylic Deck Display Holder | deckarts

Hang a skateboard deck horizontally with a clean, floating look. Each mount is an acrylic block with two stainless-steel threaded rods that pass through your deck's truck holes, so the deck sits just off the wall. Ships from Berlin.

deckarts decks come bare, with nothing fitted on the back, and the mount is sold separately. These mounts fit them, and most other decks too.

Key features

• Floating look: the deck sits off the wall on the acrylic block.
• Uses the truck holes: fits the standard 41 mm (1.625") truck-hole spacing found on most skateboard decks, including every deckarts 85 × 20 cm deck.
• Acrylic and stainless steel: block of reinforced clear acrylic, laser cut and hand polished, with stainless-steel rods, nuts and black cap nuts.
• One wall screw per mount: works on solid walls and drywall.

What's included (per mount)

• 1 × clear acrylic mounting block
• 2 × stainless-steel threaded rods with nuts and black cap nuts
• 1 × stainless-steel wall screw

How many to order: 1 mount per deck. A diptych needs 2, a triptych needs 3.

How to install

1. Hold the deck where you want it and mark the mount position under the truck holes. Use a spirit level.
2. Drill a 5 mm (3/16") pilot hole at the mark and, if your wall needs it, push in a suitable wall plug.
3. Screw the acrylic block to the wall.
4. Pass the threaded rods through the truck holes, then fit the nuts and black cap nuts and tighten them.
5. Check that the deck is level.

Not sure whether to go horizontal or vertical? Read How to Hang a Skateboard Horizontally or Vertically. Prefer your deck behind glass? See our skateboard frame guide. Hanging a set? See our diptych and triptych collections.

Other ways to display

• 360° Rotating Wall Mount: hang a deck at any angle.
• Floor Stand: display a deck without drilling the wall.

FAQ

How many mounts do I need?
One per deck. Each mount is sold individually.

Will it fit my deck?
It fits decks with the standard 41 mm (1.625") truck-hole spacing, which covers most skateboard decks, including all deckarts decks.

Do I need to drill?
Yes, one 5 mm (3/16") pilot hole in the wall per mount (wall plug not included, so use one that suits your wall type). Nothing is drilled into the deck, because the rods use the existing truck holes.

What walls does it work on?
Solid walls and drywall. Use a wall plug suited to your wall type.